|
Post by nichtschwimmer on Feb 7, 2022 22:17:19 GMT
Hi,
I already created different USB-sticks but after starting with the RGL and then showing the PCUAE splash screen it restarts after some time with thev original firmware. I'm using a 32GB Sun Disk ultra formatted to FAT32 and did all steps mentioned in the Walkthrough. I exported the games and Favourites 1 to the games folder.
The log entries are: log-1b-pcuae-mode-changer-startup-by-user-ok log-1b-pcuae-mode-changer-startup-ok log-1-pcuae-gadget-and-kernal-module.drivers-ok log-2g-pcuae-mode-enabled-no-fw-script-ok log-2h-pcuae-mode-enabled-no-fw-starting-up-enable-screens-ok log-2-pcuae-mode-checking-mode-startup-ok
Any advice would be helpful!
regards Jörg
THEC64 PAL FW 1.6.1
|
|
|
Post by spannernick on Feb 8, 2022 9:19:47 GMT
It looks like its loading the carousel... 3. PCUAE Mode(No Autoboot Mode Start-Up Script Installed) log-2g-pcuae-mode-enabled-no-fw-script-ok log-2h-pcuae-mode-enabled-no-fw-starting-up-enable-screens-ok
Thats tells me its booting PCUAE Mode from Fake Update.
I updated the carousel_gamelist_changer.sh script in pcuae1.7.6b9-setup.exe so if it is restarting to load Firmware Mode then it not installed, it does not do that now, you need to install it over the top of pcuae1.7.6b8-setup.exe.
|
|
|
Post by nichtschwimmer on Feb 8, 2022 16:38:47 GMT
Hi,
I've already installed pcuae1.7.6b9 over 1.7.6b8. Is there a newer Version ?
I'Ve prepared a complete ne stick with just 1.7.6b8 and the update to b9 and exported just the Favourites 1 to keep it as clean as possible. Same behaviour, same logs.
|
|
|
Post by spannernick on Feb 8, 2022 23:33:19 GMT
|
|