Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Nov 6, 2020 13:51:46 GMT
I now have 2 c64 maxi computers. Both are supplied with a 5Volt 1Amp adapter. I had plugged a usb tester between the c64 and adapter. Output power 4.89Volt and with 1 microsd and 2 joystick`s this 680MA pulled. I will now order others, because 1 Amp is very tight. Power supply: 5V 2A or 3A(Sometimes it has the wrong type of power adapter in it box with THEC64 MAXi, its best if you use a 5V 3A with it like the Orange PI PC uses and stops THEC64 Maxi crashing randomly. |
|
|
|
Post by spannernick on Dec 18, 2020 14:21:50 GMT
Just noticed something.... You can see THEC64 Maxi/CHA Logic Board was built with the same design of THEC64 Mini's Logic Board, they are both the same size, it has markings on the left side of the board for 2 USB ports and a Power button, it even has the hole in the board, top right if board is upside down top left if board facing up, where one of the screw posts goes through it on THEC64 Mini's top part of the case, so you could fit this board into THEC64 Mini's case, if you soldered 2 USB Ports and a power button on the board, it should work in it too but might have to test the USB Ports first to see if they work and not missing any resistors and that, you would need to cut a hole in the back on THEC64 Mini's case for the other USB port on the board too. The screw holes are in the same place too, they replaced the sd card slot on THEC64 Mini Logic Board for a USB port on THEC64 Maxi's Logic Board.   |
|
